the machine
you need:
crest spinbrush pro vibratin tooth brush
E or .012 guitar string
tape
bic mechanical pencil
petroleum jelly
about a 1 millimetre drill bit
wire cutters
sterile rubber gloves
bowl
bleach
boiling water

steps
1. take the head off of the tooth brush
2) pull out the eraser and cut it in half as even as possible
3) screw a hole in it and smooth it out.
4) take the guitar string and cut it to about 3 inches. then bend a small portion of the end at a 90 degree angle.
5) get the black tip off of the mechanical pencil.
6)pour a bowl of bleach and soak the guitar string and tip in it. then dip it in and out of boiling water so it doesn't melt or get misshapen. do this alot of repetitions.
7) put the gloves on and slide the eraser down the string so the eraser is held on by the bent string.
8)put a small amount of petroleum jelly around the eraser. now push it down in to the top of the toothbrush as far as you can. turn on the toothbrush and make sure it goes up and down but dont come out. if neccesary put a miniscile amount of superglue in the hole in the eraser.
9) take the tip of the mechanical pencil and slide it over the guitar string.
10) take the wire cutters and cut it short enough so the tip dips into the pencil tip.
11) dip it in ink while it is on, then press hard on the skin and drag it along
~~~~~~~~~~~~~~~~~~~

the ink. method
you need
a plastic cookie container
a lighter
small pot
scisors
plastic bag
razor
water
tin foil

how-to
cut the plastic into about 1 square in pieces.
put the pot on the stove
put the plastic in the pot
dirctly light the plastic with a lighter. soak in flammable liquid if necessary
put the bag over the pot upside down to catch the soot. if neccesary put a little water inside the bag to keep it from melting and to catch the soot.
with the razor, cut the bag open and scrape the soot onto a plate.
put it in a bottle with about 2 drops of shampoo and about 1 OZ. of water
~~~~~~~~~~~~~~~~~~~~~

the stencil
you need
a graphite pencil or pen taht can make thin lines(fine point sharpie)
wax or tracing paper
speed stick deodorant (the white stuff no gel)
razor and shave cream
rubbin alchohol

to do
draw the stencil on the paper and make the lines really dark
shave and clean the entire tat area
put a light layer or speed stick on the entire area
press firmly down try your best not to smudge it and hold it down for about 30 seconds and lift it off.

i don't totally follow the ink part, but i'm gonna try to make that gun once i have enough money for an electric tooth brush......(ya i'm that broke now)

great info though, unfortunately none of my friends can draw and i can only give myself a tattoo that will look halfway decent (probably not)

not many views