I was reading up on wikihow on to hot wiring a car. Not too hard just rip out the space under the wheel, put the two wires directly under the ignition together, and it should be fine. Are there any other methods to do this. (easier preferrably.) Note: If you try doing this on newer cars, alarms could go off. is there any way to bypass this too.

No it said anything after 1995 it wont work.?

most likely it will work just make sure it doesnt have the sticker on the window that says alarm or something. and some cars have little alarms you can buy inside so check for that too. also dont be an idiot and try it on the nicest car you see

thats bulllllllllssssssshhhhhiiiiiiittttttttt
if you only connect 2 wires theres 1 missing.
you need to activate the ignition (what happens when you turn the key to "on" or "run")
and you also need to engage the starter (what happens when you turn the key to "start")
but you cant have the starter going while your running the motor
which is why the key turns back to "run" after you let go of it.
also, there are different style ignitions used in different cars so a green
in one make might be a yellow in another. luxury vehicles
often differ from other vehicles.
know how the ignition works before trying to start it.
it may be easier to start it from under the hood too. so look into it first.

Ill just have to try it and see what happens

on the older ones you can jest brake the key hole (with flat blade and maybe a hammer) and in side theres a flat lever and jest turn (with pyres) that and it would crank over...



to get in side a locked door (still old car) ... take a peace for square tubin and brake the lock plate off then with the tubing bash the lock in wards (in door) then with a screwdriver push DOWN on that lock you jest pushed in and the lock should pop-up