hey tell me wat you think of this.

take a light tube and break it so that the little curley wire dosent break or fall out. have bout a foot of tubing after you break it. then fill the tube bout halfway with black powder, or nethin thats gonna blow up. then get a long wire and hook ip up to the metal part and run the line behind a tree or somethin, then hook it up to a switch and a car battery or nethin that could b used to make that coil light up so it sets off the contence in the tube. think it would work, or is it a waste of time?

It would prob. just ignite the powder, if you put the powder under pressure with something you might could get a bang

i just went out and tryed this, all i had was gun powder that i pulled outa some 30 cal. shells. it didnt do much but it made a huge fuckin flare like 8 feet in the air. i almost caught a tree of fire. id be willin to bet if you used that flash powder stuff or like cole said, find a way to compress it, it would make a pretty good bang.

I used to use christmas tree bulbs cut in half with a file as electric ignitors in AP caps.

Talking about light bulb's ...

You can also make a small incision into the glass with very small and fine powerdrill head....Fill it with a arasole bottle of Butane.Cover the hole with a bit of bluetac ,then tape....... Put it in someone roof light and when they turn it on it will explode..... do not put it in a lamp for they have to put there hand close to it to turn it on and will probably get cut up from the glass